Crosley Range / Cooktop / Oven Spark Module

• Won't start

Replaced srark module Read more

I tried swapping the cables around by putting the cables from the burners that would light onto the ones that didn't light. When I did that the problem would move. So this is how i determined that the issue was with this module and not the burners or cables. Once this new module arrived it was simple to disconnect the old one and put the cables back on the new one. I tested it (holding by breath!) and then all of the burners started. HOORAY! Read more

Replaced spark module - oven was less than two years old. Like a lot of new gas ovens, turning on any one burner to 'lite' sends sparks to all 5 top burners. The difficulty was getting to the spark module, as some generic videos show access to it from the upper panel on the back of the oven, but it wasn't there. Had to take off the entire top burner panel of the oven to get to the module, and then it was simple to replace the module by transferring the wires to the new one. I did see on... Read more

Watched repair video's to learn where parts were located. Put replacement in and it worked great! Read more

Replaced the ignitor module ( a plug in direct replacement) a monkey could have performed this repair Read more

Replace spark module. Read more

Began by replacing the burner and igniter assemblies. Learned that was not the solution. Proceeded with further diagnosing. Consulted online resources, such as Maytag website, and discovered that the two likely causes were either the spark module or wiring harness. Ordered both parts, and replaced inside of the oven. Figured out the problem ended up being a bad wiring harness. Read more