Parts for Ge PSC23NHMABB: 10 - Custom Cool Parts

Replace your refrigerator water filter every 6 months to maintain clean water and ice. Removes contaminants for fresh taste. Easy DIY install in minutes.

Replace cracked or missing dispenser trim that leaves exposed edges on your refrigerator door. This molded piece restores a clean, finished look.

Replace your refrigerator's grill mullion cover when it becomes cracked, broken, or discolored. This decorative trim installs on the front grille area.

Upper hinge cover cap for refrigerators. Replaces cracked, broken, or missing decorative covers on the top hinge assembly. Restores clean appearance.

Fix a warm Custom Cool drawer or knocking noise from the bottom compartment. This fan assembly restores proper airflow for faster chilling. DIY repair.

Fix food freezing or warm spots in your fridge with a new air damper assembly. Controls airflow between compartments. Moderate DIY repair, 1-2 hours.

Fix loud tapping or knocking noises and uneven cooling in your fridge. This air damper restores balanced temperature control. DIY repair in about 1 hour.

Seals the vertical door mullion area to keep cold air in and reduce condensation. Replace when worn or damaged to restore proper sealing. Confirm fit.

Fix frost buildup in your refrigerator's custom cool area with this defrost heater. Melts ice during defrost cycles to restore proper air flow.

Fix dim or non-working refrigerator lights with a new light socket. Replaces melted or damaged sockets. Simple 15-minute repair for most models.

Illuminates the crisper drawer area in your refrigerator. Replace when bulb burns out or flickers. Verify fit with your model number before ordering.

Light cover lens for refrigerator chill drawer or interior compartments. Replace when cracked, discolored, or missing to restore proper lighting. Verify fit with your model number.

Seals the air handler chill compartment in your refrigerator, preventing warm air infiltration. Replace if torn, cracked, or causing temperature issues.

This wiring harness connects the refrigerator's chill/evaporator circuit to the control electronics, restoring reliable power and signal routing for cooling components. It helps return proper operation when wiring or connector damage interrupts the chill circuit. What it does:

• Routes DC power and signal between the refrigerator control board and chill/evaporator components
• Replaces damaged or corroded connectors that can cause cooling or temperature control issues
• Can stop intermittent operation caused by loose or broken wires in the chill circuit
• Supports proper function of fans, sensors, and related chill components that rely on the harness

• One wiring harness as pictured and specified by the manufacturer

• Disconnect power to the appliance before beginning any repair
• Inspect connector ends and mounting clips; do not splice unless explicitly recommended by the manufacturer
• Match connector shapes and pin counts before installing to avoid damage

Replace your refrigerator's air handler chill seal gasket to maintain proper temperature zones and prevent air leaks. Verify fit using your model number.

Seals the chilled compartment to maintain proper temperature and prevent warm air leaks. Replace if torn, cracked, or no longer sealing tightly.

Refrigerator door gasket foam seal creates an airtight barrier. Replace if door doesn't seal properly, increasing energy use. Verify fit with model number.

Seals refrigerator door to maintain temperature and energy efficiency. Replace if cold air escapes or seal is cracked. Verify fit with model number.

Fix uneven cooling or defrost issues with a new temperature sensor. Most DIYers complete this repair in under an hour with basic tools and our video.