Parts for Ge PSS25NGMBBB: 10 - Custom Cool Parts

Replace your refrigerator water filter every 6 months to maintain clean water and ice. Removes contaminants for fresh taste. Easy DIY install in minutes.

Refrigerator mullion grill cover that sits between fresh food and freezer sections. Replace if cracked, broken, or discolored to restore appearance.

Fix a warm Custom Cool drawer or knocking noise from the bottom compartment. This fan assembly restores proper airflow for faster chilling. DIY repair.

Fix food freezing or warm spots in your fridge with a new air damper assembly. Controls airflow between compartments. Moderate DIY repair, 1-2 hours.

Fix loud tapping or knocking noises and uneven cooling in your fridge. This air damper restores balanced temperature control. DIY repair in about 1 hour.

Seals the vertical door mullion area to keep cold air in and reduce condensation. Replace when worn or damaged to restore proper sealing. Confirm fit.

This thaw heater is the evaporator defrost heating element that melts frost during the refrigerator's defrost cycle. Replacing a failed heater helps restore normal defrosting and reduce frost buildup that can restrict cooling. What it does:

• Heats the evaporator coil during the defrost cycle to melt accumulated ice
• Prevents excessive frost buildup that can block airflow and reduce cooling efficiency
• Common symptoms of a failing heater: heavy frost or ice on the evaporator/back wall, reduced cooling, or long compressor run times
• Works as part of the appliance's defrost system alongside the defrost thermostat and control

• Disconnect power to the appliance before starting any repair
• Access typically requires removing interior panels and the evaporator cover; handle the evaporator and wiring carefully
• Inspect associated defrost components (thermostat, timer/control) if problems persist; replace only parts confirmed faulty

Fix dim or non-working refrigerator lights with a new light socket. Replaces melted or damaged sockets. Simple 15-minute repair for most models.

Lamp 40w chill

Seals the air handler chill compartment in your refrigerator, preventing warm air infiltration. Replace if torn, cracked, or causing temperature issues.

This wiring harness connects the refrigerator's chill/evaporator circuit to the control electronics, restoring reliable power and signal routing for cooling components. It helps return proper operation when wiring or connector damage interrupts the chill circuit. What it does:

• Routes DC power and signal between the refrigerator control board and chill/evaporator components
• Replaces damaged or corroded connectors that can cause cooling or temperature control issues
• Can stop intermittent operation caused by loose or broken wires in the chill circuit
• Supports proper function of fans, sensors, and related chill components that rely on the harness

• One wiring harness as pictured and specified by the manufacturer

• Disconnect power to the appliance before beginning any repair
• Inspect connector ends and mounting clips; do not splice unless explicitly recommended by the manufacturer
• Match connector shapes and pin counts before installing to avoid damage

Replace your refrigerator's air handler chill seal gasket to maintain proper temperature zones and prevent air leaks. Verify fit using your model number.

Seals the chilled compartment to maintain proper temperature and prevent warm air leaks. Replace if torn, cracked, or no longer sealing tightly.

Refrigerator door gasket foam seal creates an airtight barrier. Replace if door doesn't seal properly, increasing energy use. Verify fit with model number.

Seals refrigerator door to maintain temperature and energy efficiency. Replace if cold air escapes or seal is cracked. Verify fit with model number.

Fix uneven cooling or defrost issues with a new temperature sensor. Most DIYers complete this repair in under an hour with basic tools and our video.