Parts for Comfort-Aire BHD-301: Dehumidifier - Model: Bhd-301 Parts

This turbo fan assembly moves air through the appliance to help maintain proper airflow and cooling. Replacing a worn or damaged fan restores efficient venting and helps prevent overheating or reduced performance. What it does:

• Spins to circulate air through the appliance's blower housing or heat exchanger
• Restores proper airflow when a failing fan causes weak output or longer cycles
• Reduces unusual noise caused by warped or imbalanced fan blades
• Helps prevent overheating by maintaining designed ventilation

• Disconnect power (and gas if applicable) before starting any repair.
• Handle the fan carefully—blades can be sharp and alignment affects balance.
• Inspect mounting hardware and seals; replace any damaged fasteners or gaskets.

This compressor isolator is a rubber mount that cushions and reduces vibration and noise from the compressor, helping keep the appliance quieter and preventing metal-to-metal contact. What it does:

• Dampens compressor vibration to reduce noise and rattling
• Helps prevent compressor movement that can strain mounting hardware
• Reduces transfer of vibration to the cabinet and surrounding components
• Commonly replaced when vibration noise or scraping is heard from the base

• One compressor isolator (rubber mount)

• Disconnect power to the appliance before any service and work with the appliance unplugged
• Access may require tilting or moving the appliance; use safe lifting practices and get help if needed
• Inspect surrounding mounts and hardware; replace like-for-like and verify fit before final assembly

This thermistor assembly is a temperature-sensing component that provides accurate feedback to the appliance control system so temperature and defrost cycles are regulated properly, helping maintain consistent cooling performance. What it does:

• Senses evaporator/compartment temperature and sends a signal to the control board
• Helps the control system time defrost cycles and manage compressor run cycles
• Commonly linked to symptoms such as frost build-up on the evaporator, irregular temperatures, or defrost-related fault codes
• Passive component — will not operate correctly if connector, wiring, or control board is faulty

• Disconnect power to the appliance before servicing to avoid shock or damage
• Handle the sensor tip and wiring gently; avoid bending or stressing the sensing element
• Ensure the connector is fully seated and wiring is routed the same way as the original
• For exact location and replacement steps