Nabil D Amarillo , TX November 09, 2014 Appliance: General Electric Refrigerator PSS29NGPBCC Panel is cracked and it does not dispence water or ice Replaced interface display and main control board. I saw videos and asked for some help from the store. Information on your web site helped. Specially about the dimming light on the display assembly is an indication of main board went bad. I used a patty knife to remove the front panel around the interface display as suggested by your rep. EXCELLENT SERVICE AND DELIVERY. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Pliers
Charles C North Fort Myers , FL August 20, 2019 Would not change from water to ice Ordered the new part as soon as it came in the mail the refrigerator started working correctly. I am keeping the new part as it will probably go bad again soon. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
Rita V Bluffton , SC April 27, 2019 Ice/water dispenser in the door of my refrigerator was spewing out water or ice in a continuous stream and i was unable to get it to stop this was kind of funny but a real disaster! While working in the back of my house, I kept hearing a rhythmic popping noise and finally decided to find out what was causing it. When I entered the kitchen, I saw a steady stream of water pouring from my refrigerator water dispenser. I changed the selector to ice and ice cubes were thrown across the floor. Using a little common sense, I knew I had to break the electrical connection between the freezer door and the dispenser. So, by leaving the door ajar enough that the freezer light stayed on, the flow of water stopped. Next, I called my husband off the golf course to come home and help me. Next I got on the internet to see what was causing the problem. Luckily, I discovered a video by AppliancePartsPros on YouTube which showed me the problem and how to disconnect the electrical connector underneath the front of the freezer door which my husband managed to do. I called the helpline at AppliancePartsPros and spoke with Nathan who was very helpful. After I gave him the model number of my refrigerator he was able to find the correct part which was the ice/water selector panel. He had this in stock and shipped it to me. The part arrived 5 days later. Using a putty knife, a screwdriver and a pair of pliers, my husband was able to install the new panel and put everything back together in less than a half hour. It took me longer to clean up about two gallons of water off my kitchen floor. Thank you AppliancePartsPros and Nathan for your assistance. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Pliers, Screwdrivers