Richard S Rochester , NY January 19, 2015 Appliance: Model HOTPOINT RGB745BEA2AD Igniter failed so oven did not work Removed old igniter, checked continuity with an ohm meter to determine it was defective. Ordered new igniter and replaced it, oven now works great. About a 15 minute repair. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers, Socket Set
Mauro Q San Bruno , CA March 04, 2016 It needed an oven bottom Unscrewed the old panel and once the screws were out then pull the old panel up from the back. Remove it by sliding it out and replace it with the new one and drew it back in. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
William F Sterling , MA January 24, 2016 Oven bottom was so corroded it had holes in it! Attached old heat shield to bottom of oven bottom panel and then installed oven bottom. Extremely easy repair and part arrived promptly. Very satisfied. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
John E Elk Grove Village , IL November 20, 2015 Oven bottom panel because of age of stove was rusted and hard to clean Purchased new oven panel bottom and replaced the old with the new. Appliance Parts sent new panel within a couple of days, was the right one and I was very satisfied. Would definitely use Appliance Parts Pros. again if need. Thank You Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Eileen H Delmar , NY April 18, 2015 Bottom plate rusted on gas stove Ordered the part, it arrived 2 days later, unscrewed the old plate, put new one in. Very simple. It would have been nice to get 2 new screws too, but I made the old rusted ones work. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers