How to Troubleshoot & Replace Lg AP4437130 / 3110JA1096A Display Case (Control Panel Housing)

Had to replace light lens, and lens housing. Two screws hold the housing to the roof of the fridge. The instrumentation cluster is held to the housing with three screws which requires carefully peeling off the touch screen sticker which then can be reapplied after the instrument cluster is swapped into the new housing. Replace std bulbs with either fluorescent, or LED bulbs to prevent further problems....like fires. 

I pulled out the frig & unplugged it I unplugged the wire to the control. Unscrewed the two screws that at the time were holding up the reflector for the lights. Took a scraper with a very thin blade to pull the face cover for the touch screen control away to get the three screws removed that hold the control in place. Placed the control panel into the case display .. attached with the three screws. Put the touch screen back over the control without needing any glue. Enough was still on it. Placed the case into it's proper place & attached with the two screws. Re - attached the wire to the control by simple plugging it in. Plugged in the refrigerator. Opened the door & all was working correctly. Rolled frig back the 6" I had pulled it to unplug. 

Replaced Pcb board. After verifying Pcb corrected light problem. Replaced display case. 

Replaced warped cover and frame that were warped. As mentioned in other comments take care on removing strip in front 

Our refrigerator door had sprung open so we didn't see the lights on. The incandescent bulbs heated up and melted the control frame and cover. I received an email with a line for each of the two repair pieces. Each part line had a video link that described in outstanding detail how to complete the project. I followed the video instructions and they worked like a charm. I loved the exceptional video support given and would absolutely purchase parts again from this company. I also replaced the bulbs with LED to avoid future heat problems. 

Watched videos on appliance parts pros.com, making for an easy change-out. Instead of using a heat gun to remove the front sticker over the control panel touch pad, I used a hair dryer. Then, instead of using incandescent bulbs, I replaced them with A15 40W LED daylight bulbs. What a nice change. And they don’t heat up! 

I replaced the pcb display and covers. 

I ordered the 2 parts listed, but only need one, and the gentlemen who does the videos showing how to replace it was exact, and made it so easy for me...The only thing different is I used my hair dryer to heat up the label to remove, he used a heating gun (I'm a girl so I used what I had which worked great) lol. 

In 15 minutes, after part arrived. 

Ordered new parts and replaced them