Ryan H Oak Creek , WI March 17, 2017 Appliance: Maytag Undercounter Dishwasher MDBH955AWQ0 Dishwasher not filling with water Replaced the water inlet valve and float switch. Read More... 15 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Pliers, Screwdrivers, Socket Set, Wrench Set
Adam M Watertown , MA October 18, 2015 Tenants (most likely) overloaded the dishwasher and jammed it closed breaking off the float which then melted on the coil Replaced both the float and switch. Read More... 7 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Pliers, Screwdrivers, Socket Set
Terry E Scott Township , PA October 21, 2019 Did not fill with water Replaced the sensor and float following the directions in the video. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Pliers, Screwdrivers, Socket Set
Steven S Billerica , MA January 03, 2017 Appliance: Maytag Undercounter Dishwasher MDBH965AWB40 The dishwasher was overfilling and leaking out front I replaced the float switch and the drain pump. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 2+ hours Tools: Adjustable Wrench, Nut Drivers, Screwdrivers, Wrench Set
Russell M Nederland , TX April 05, 2016 Dishwasher leaking from bottom front tub onto floor during washing8 Installed new lower washing arm. Old arm seam opened up on one bottom side allowing water spray from arm bottom into tub when washing. This apparently caused water in washer tub to create waves from the rotating washer spray arm. The water from tub splashed out tub bottom front and ran onto the floor. Sure glad I researched causes on www and checked the old washer arm for problems! Almost bought a new dishwasher when only the lower washer arm was problem. Two minute install and problem with leakage from tub front bottom fixed! Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Adjustable Wrench
Dennis P Bitely , MI November 10, 2014 Appliance: Model MAYTAG BUILT-IN Door latch broken float switch flakey Remove inner part of door, disconnect both sets of wires, lay new handle in place connect wires and replace door panel. It was that easy. The hard part was figuring out which setup to order. I guessed right! The float switch was more difficult. You had to lay on the floor and work under the unit with the screw mount on the back side. Engineer who designed that should be fired!! Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Pliers, Screwdrivers, Socket Set