Ross M Ohiopyle , PA October 24, 2016 Appliance: Maytag Electric Dryer MDET446AYW Dryer ran but wouldn't heat the only thing i could find was the thremistor only real at 8 ohms instead of a little over 10 Installed a new thermistor tempiture control and it heats up as it should. Tools used was a ohlm meter, 1" stiff puty knife, #2 Philips screw driver, neadle nose pliers,1/4 & 5/16 nut drivers. Read More... 14 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Pliers, Screwdrivers
Thawatchai S Las Vegas , NV December 14, 2015 My dryer did not heat up Changed the thernistor Read More... 5 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 2+ hours Tools: Adjustable Wrench, Nut Drivers, Screwdrivers, Socket Set
Alex H Edison , NJ September 13, 2016 Appliance: Model 12355678 Bad thermostat Found the culprit fixed appliance parts pro you rock got my gas dryer running again thanks Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Robert S Alexandria , VA May 30, 2022 Appliance: Maytag Gas Dryer MDG4658AWW Maytag dryer. The igniter lights-gas lights soon after gas goes off and the cycle never happens again. Replaced Gas Valve Solenoids, problem is fixed. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Screwdrivers
Steve K Oakland Twp , MI July 10, 2016 I had no heat in dryer Appliance pro walked me through how to check each part to see which was bad sent me videos on how to fix It. Ordered all the parts, took me about a half hour to fix it and save me about $150 excellent customer service. Thank you to everyone that helped Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Adjustable Wrench, Nut Drivers, Pliers
Jason L Davenport , IA March 31, 2014 Appliance: Maytag Electric Dryer MDE5806AYW MDE5806AYW. Turning on but no heat. Drum light not staying on. Black wire from the motor to the heating element had melted and disconnected. Cleaned the wire, added a new female connect. Still wouldn't heat up and drum light stays on a few seconds. Breaker didn't look tripped but flipped it off and back on. Dryer works prefect again. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Pliers, Screwdrivers, Socket Set, Wrench Set