Do-It-Yourself Story

After referring to a couple of forums on the subject, I was convinced that I needed to replace the Electronic control board. Was about to order the board based on the part number associated to the video on the repair. Decided to take a look inside before ordering the part. It looked different so I did some more research. Got the Serial number and model number of the dryer to make sure I was ordering the correct part then ordered it on a Sunday. The part arrived Wednesday and I pu it in Wednesday night. I had the new one out while removing the old one to make a comparison to find any differences. There were some slight differences with the connectors and where they went but nothing requiring any alterations to the board or the wiring harness on the dryer. I removed the connectors from the old one, removed the board, installed the new board and replaced the connectors. (only needed a nut driver for the whole repair!) I then gave it a quick test run prior to putting the top back on the cabinet. Worked fine. Laundry was was back in business that night!