I've been a jack of all trades all my life. When I saw that our dishwasher quit running cycle I naturally thought it was the UI. Thats what it usually is. I then ordered a ui from APP.com and they sent me one. It didn't work so we thought it might have been defective. A new one was sent, (still in route). During the process I broke the UI cover and ordered a new one there. Should have googled it first. First cover came, wrong one, ordered a new one. Found a major leak with the recycle valve/diverter, Passive Main Assembly. Ordered that and installed that. Put the rest of it together and it fixed it all. We are glad to have dishwasher back. Spent less than $150 for repair as opposed to $300-700 for new. For this repair I had to take the washer out from under the counter, remember to cut off water and power. Remove the kick plate under the door and unplug the electrical for the UI control also under the door. Remove the hinge springs both sides then lift the door off the rest of the dishwasher. Remove 2 screws for hinges on door and 2 screws to loosen the inner door cover, unscrew the warm air exhaust port from the inner door. Push the inner cover up and then separate inner and outer door parts. Unscrew the 4 screws holding the UI in place, remove the old cover and install it. Then put all back in reverse order. The Diverter was done with the door off so I could turn the tub over to access it better. Remove the screens from inside the tub and lower washing arm. Unscrew the 3 screws holding the diverter in place. Remove the clamp from the rubber hose and remove the valve. Hardest thing was finding a replacement clamp. It seems no one carries a 5/16 wide hose clamp. Then reassemble all in reverse. Hey surprise, it works. Whooop!!