Replaced the igniter, Simple but there are several points to remember. TURN THE POWER OFF 1) remove the oven door or you will have a hard time reaching the back of the oven. Mine just lifted off. 2) The igniter tip is fragile put a drop cloth over the oven floor in case you drop it even after it is in its holder. 3) The drop cloth will catch screws too if you drop them so they won't fall into the oven. 4) The cable from the oven is very short even after pulling it out from the hole at the back. So try not to mess up the end of the wire so that you can connect to the igniter wires without clipping back and baring fresh wire. 5) The igniter holder may seem like it won't fit all the way back into the oven. Notice the rectangular hole in the oven back and make sure you get the back of the igniter holder aligned so it can protrude into that hole. The hole is small and the wires tend to make the holder catch on the top of the hole. 6) you my need someone to hold a flashlight as you put the igniter holder back in. 7) I needed long nose pliers to pull the wires and wire nuts into the oven from behind the rectangular hole in the back as my fingers wouldn't reach.