The shelf frame cracked on the outer left hand corner causing the meat draw to dip. Replacing it with the new one was easy. Before starting remove the glass insert and draw.
The shelf is supported by four pin like plastic supports in each corner. Only one of these pins lock it in place. On my fridge the one located underneath the shelf left hand side needed to be removed or loosened. This one may be shaped differently then the others. Next tilt shelf upward and slide it towards you to remove. IMPORTANT on the old shelf there is a plastic vent lid that snaps out. You will find this part on the left hand side of frame snapped into a square cutout. Remove and install on the new frame. Note, this lid directs the flow of air into the draw.
To install the new one line up the rear supports with the groves in the frame and slide it in backwards and tilt it down. It should now be resting on the three remaining corner supports. Screw in the reaming corner support and snug it tight..Do not over tighten. You're Done