Mark W Texas City , TX March 27, 2017 All the buttons on the panel would work except for the start button Removed the 6 Torx screws holding the panel to the door. Removed the 2 screws holding the door closed sensor module. Removed the ribbon pin from the controller module. Used a blade screwdriver to release the clips holding the module in to the panel. Removed the screw holding the upper portion of the door handle. Attached the upper portion of the handle to the new piece. Attached the ribbon connection to the pins and snapped the controller into panel. Attached the door sensor to the new panel. Attached the the new panel to the door with 2 Torx screws. Closed the the door for operations check. New panel checked out, installed 4 remaining Torx screws. 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes