Thomas G Gulfport , MS October 16, 2022 Appliance: LG Room Air Conditioner LW1216ER/00 Lg Room Air Conditioner Lw1216er/00: The compressor was running constantly even with the power button turned off. How to replace Air Conditioner Main Control Board. I replaced the main circuit board because the compressor relay contact was welded shut (always closed), so the compressor would never shut off unless I pulled the power cord plug from the wall receptacle. To replace the main circuit board, first remove two Phillips head screws securing the A/C tray into the window mounting sleeve - they are located on the outdoors side of the unit towards the bottom corners of the window sleeve. Back indoors, remove the front grill from the unit - don't forget to remove it carefully because you have to disconnect the ribbon cable to the front control panel circuit board from the main circuit board enclosure header while holding the front grill with one hand - and then partially slide the tray out from the window sleeve to access the main circuit board enclosure located just behind where the front control panel normally resides. Remove three Phillips head screws from the top of the main circuit board enclosure, then remove the enclosure cover. Disconnect 3 ribbon cables from the circuit board headers and two wires with 1/4" quick disconnects from the compressor relay. Towards the front of the enclosure, remove one Phillips head screw securing the circuit board to the fixed part of the enclosure housing and then remove the original circuit board. Install the new circuit board, secure it with the one Phillips head screw at the side of the enclosure near the front, and reconnect the wires and ribbon cables to the compressor relay and circuit board headers. Reinstall the enclosure cover and secure it with the three Phillips head screws. Slide the unit back into the window sleeve and reinstall the front grill - don't forget to reconnect the front control panel ribbon cable to the main circuit board enclosure header. Reinstall the two Phillips head screws at the bottom rear corners of the window sleeve on the outdoor side of the unit to secure the tray to the window sleeve. The whole job took roughly 15 minutes tops. My window unit A/C is now running normally again. Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes