Using the model number of the frig, I located the part (Interface Dispenser Asm) on the AppliancePartsPros.com. After reading the Q&A section for hints on how to change the part and looking at a couple of YouTube videos, it seemed that I was up to the task. I placed the order for the part and was pleasantly surprised that it arrived in a couple of days. Armed with a flat blade screwdriver and an old credit card, it took me about 15 minutes to first remove the bezel around the ice dispenser (using the old credit card to prevent scratches to the stainless steel finish when prying the bezel out with the tip of the screwdriver) followed by snapping out the Dispenser Assembly. It would have taken less time to do this had I not been overly cautious not to crack the plastic bezel when prying it off with the screw driver. It took a few seconds to disconnect 3 connectors between the old part and the frig door and reattaching them to the new part. When the bezel was snapped back in, the frog looked like new!