T started out replacing the start capacitor but the unit would run for five seconds and cut out. I pried the controller off the compressor and that’s when I found the burn marks on the controller from overheating. I ordered the controller, plugged it all in and it’s back to cooling. I would recommend getting the capacitor and controller as a set as the older capacitor does not line up properly with the new style controller. You will need a crimping plier to join the wires. My only observation is the older controller had the load and neutral pins clearly marked. The new controller and plug lead are not color coded nor is the plug marked for the load or neutral side. I hope I got it right.