Unplug the refrigerator or disconnect from the power source. Remove the old control module. Remove two Phillips head screws from under the trim piece and set them aside. This will expose two more Phillips screws at the bottom of the control module. Remove the two screws and carefully pull the control module down and away from the refrigerator. There will be four-pin connectors on the back of the control panel. Gently squeeze the connectors and remove them from the control module. Install the new control module by reconnecting the four connectors ( the connectors are polarized and cannot be installed wrong). Gently slide the control module's top two pins up in the refrigerator door and push in. Reinstall the two Phillps head screws at the bottom of the control panel. Reinstall the trim piece with the two Phillips head screws under the bottom. Reconnect the refrigerator to the power supply. Easy installation!!!