I think the faceplate was damaged during original installation as the clear plastic control unit was also cracked. I fixed that crack with model cement. Everything can be taken apart with a 1/4" nut driver. Be sure and unplug the unit first! Take off the upper back panel with 4 screws. Take out the control unit with 4 screws. Peel away the old faceplate graphics, there will be sticky residue left on the control unit. I cleaned all that up with paper toweling and paint thinner (mineral spirits) and my fingernail. There are tabs on the bottom and right edges of the control unit to align the graphics sheet. Peel away the backing from the faceplate to expose the adhesive. Rest the graphics along the bottom two tabs and align to the right tabs. Then lower the sheet onto the control panel smoothing it out toward the opposite corner. Peel off the front protective sheet. Install everything back as it was. Most of the time is spent cleaning off the old adhesive.