Robin C Trinity , FL February 07, 2018 Appliance: Model GE STOVE 2015 Oven control shorted out when I attempted to change oven bulb. No love for GE and less for repair servicer. Few you tube videos and your parts. I’m back in business. Thanks. Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Pliers, Screwdrivers, Socket Set
Robert B Marion , IA March 01, 2025 F2 After trying temperature probe first. Changed control board, three cooks and no problems yet. Board number had changed, but instructions included the code to enter for my model. Very simple and easy repair. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Pliers
Jimmy J Ellendale , ND January 06, 2024 Appliance: General Electric Electric Range JB250RK1SS Circuit board wasn’t working. Order new circuit board and new panel. Repair was very easy with step-by-step instructions that came with the new parts. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Robert S Killeen , TX December 10, 2017 Appliance: Model PULL OUT THE PAN DRAWER AND FIND THE STICKER. Cracks in the face plate graphics panel. I think the faceplate was damaged during original installation as the clear plastic control unit was also cracked. I fixed that crack with model cement. Everything can be taken apart with a 1/4" nut driver. Be sure and unplug the unit first! Take off the upper back panel with 4 screws. Take out the control unit with 4 screws. Peel away the old faceplate graphics, there will be sticky residue left on the control unit. I cleaned all that up with paper toweling and paint thinner (mineral spirits) and my fingernail. There are tabs on the bottom and right edges of the control unit to align the graphics sheet. Peel away the backing from the faceplate to expose the adhesive. Rest the graphics along the bottom two tabs and align to the right tabs. Then lower the sheet onto the control panel smoothing it out toward the opposite corner. Peel off the front protective sheet. Install everything back as it was. Most of the time is spent cleaning off the old adhesive. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers
Ted Q Purvis , MS November 08, 2025 Oven went out power to the board but board did not light up and no control for the oven or broiler or clock Put in new control board and face plate. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers