Jeffery H Mundelein , IL November 04, 2016 Appliance: Model KENMORE ELITE (CONTROL PANEL #WP8282546) Defective control panel (possible bad membrane switch) dryer would continuously beep while running and most switches did not work Removed Control Panel and Control Board from top of dryer. Note that the Control Board mounting bracket is glued to the Control Panel (membrane switches) and must be cut free with a knife. Brake Clean did a good job cleaning the remaining residue off the bracket. I used silicon caulk to reattach the bracket to the back of the Control Panel, using clamps to hold in place while it dried. The rest of the repair was pretty straight forward and was easy to reassemble. The new Control Panel fixed the problem and the dryer is operational again. 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes