If I opened door and held door switch, started dryer, turned drum by hand, quickly closed door and pushed start again before drum stopped turning, dryer worked fine. Apparently the part of the motor that gives it more juice on start up went bad. Ordered motor on Monday, received on Wednesday. Blower wheel would not come off the shaft of old motor, chiseled off as shown in motor installation video. Apparently wheel becoming fused to motor shaft is a common problem based on all the comments. Ordered wheel on Wednesday, received on Friday. Both parts were easy and quick to install. Dryer started and works great. What takes the most time, but is not at all difficult, is taking the cabinet apart and putting back together. My dryer has 2 blue wires that plugged into receptacles on the motor mount, the other ends had spade clips that attached to receptacles on the motor. I watched at least three motor installation videos, and not one of the dryers shown had these wires, however I could see the receptacles on the motors they were installing. I guess these,what appear to be ground wires, are not on all models that use this motor. I am glad I did not remove the old motor and these wires before new one came in because I would have not remembered where these wires went as there are several receptacles that look the same but are not used by my dryer.