Changed out the door sensor and door latch, and Aqua sensor. Found after changing those 3 parts the same problem. However, I started looking at wiring harness from the control module on bottom right to door panel control and sure enough a partially cracked and exposed wire. That was the problem. I also noticed 2 other wires that were about to break. So I re-spliced 3 of the wires and reattached with wire connectors. Broken wires near the bottom I think the opening and closing of the door over the past 6 1/2 years created stress on wires. Problem solved. Plus I’ve got new parts in the machine but hey cheaper than a repair guy out here. Plus also learned how to change rinse aid and salt for water hardness issues.