I put the washer through the spin only cycle and I found it went from 12 minutes down to 6 minutes and then would stop. After making sure that the door lock was not the issue but making sure that it still would lock, I then checked the motor to make sure the voltages were correct with an OMs meter. I then figured it must be the control board. I received the control board in the mail, I unplugged the unit, took the back off the washer, took the motor out (easy to do by loosening a few screws) and then took the old control board out and unplugged all of the plugs from it. Then I put the new unit in and plugged the plugs back in and put it and the motor back in. I then plugged the machine back in and tried the machine and it worked perfectly!!!!!! It was easy to do.