Through the APP website, I was pretty darn sure this was the correct part. I watched the installation video a couple times, and felt pretty sure I could handle it. The only issue I had was cleaning the old adhesive off the drum. The video made it look a lot easier, but probably 90% of my repair time was sanding that off. (I wish I could have found a chemical solution. I didn't have any luck with solvents I had on hand.)
Otherwise, it was straightforward, just like the video. The adhesive tube was pretty messy to work with. There's PLENTY of adhesive in the tube, so if I did it again, I might squeeze a big glob into the garbage can to start, so that it wasn't coming out of the tube on its own accord.
THe "other" tools below were sandpaper and clothespins, both of which are shown in the video.