Roger H Sewickley , PA November 05, 2014 My ge front loader was stopping mid cycle with a t2 e22 error code Troubleshooting guide said no water, but in fact there was too much water because the water level sensor was not operating properly. Code check said E22 - Fill timeout. Reason was that the air hose feeding the water level sensor had a pin hole. There was a spot on the hose between the 2 foam donuts that seems to have worn due to flexing. Air leak prevented pressure from reaching the water level sensor. Replaced the hose - problem solved! 5 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours