Roger H Sewickley , PA November 05, 2014 My ge front loader was stopping mid cycle with a t2 e22 error code Troubleshooting guide said no water, but in fact there was too much water because the water level sensor was not operating properly. Code check said E22 - Fill timeout. Reason was that the air hose feeding the water level sensor had a pin hole. There was a spot on the hose between the 2 foam donuts that seems to have worn due to flexing. Air leak prevented pressure from reaching the water level sensor. Replaced the hose - problem solved! Read More... 5 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Pliers, Screwdrivers, Socket Set
Jackie S Columbia , SC September 01, 2014 E22 Replaced the air pipe. There was obvious rub with a tiny hole in it. I replaced it and added some pipe insulation to the exposed parts. Works just fine now. Would have taken maybe 15 min but those tiny clamps were very hard to remove/replace on the bottom end. Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Ryan M San Antonio , TX June 17, 2020 Washer kept pausing after starting or restarting a cycle, had to use drain & spin cycle to complete loads Swapped out the inlet valve after seeing the E22 error. Washer works like a champ again. Loads are done faster and clothes seem to rinse better thanks to the new part. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Pliers, Screwdrivers