Douglas C Tiburon , CA September 09, 2017 Appliance: KitchenAid Hot Water Dispenser KHWS160VCR1 Kitchenaid Hot Water Dispenser Khws160vcr1: My hot water got very un hot. How to replace Fuse - Thrml. Turned off the water supply, unplugged the heater, then used pliers to release the clamp on the plastic outlet tube. I had to cut the tubing when I couldn't get it to come off the metal pipe. Unscrewed the quick-connect copper supply tube. I could then lift the heater off the mounting bracket (no tools) and quickly pulled it out. Used plumber's wrench to unscrew the 9/16" drain plug over the sink to drain the water. Put the plug back in. Remove the thermostat knob by pulling, removed two screws holding the cover over the thermostat. Remove two screws on either side holding the unit's top on. You may have to clean the tubing gaskets to pull the top off. I had to cut the plastic tubing carefully off the outlet pipe where it had fused and hardened over the years before I could pull the top off. One end of the thermal link is right under the cover, pliers will remove easily. The other end goes to the bottom of the thermostat, also pulls off easily with pliers. Replace the part, reassemble the unit. Remount, reattach the tubes, do NOT plug in until you've used the sink knob to refill the internal reservoir with water or you'll just burn out the link again! Once filled, NOW plug it in, wait 15 minutes or so for it to heat, and you should be done, unless the thermostat was also faulty (I took a chance it was just the fuse to avoid the much greater cost of the thermostat unless necessary). The contacts sometimes arc over time, so this would be the next step, same disassembly required, just one nut that holds on the thermostat accessible behind that cover plate, with two push-on electrical connections. Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours