After removing the ice bin, remove the screw holding up the bottom of the ice maker. Next, removed the screw holding plastic cover on the left side. Slide cover forward to remove. Disconnect large electrical connector behind the cover and free cable from clips.
Lower the bottom of the ice maker to reveal freezing coil. If there is ice build up in the back of the ice maker, use a hair dryer to melt away ice. (Do not use on high heat.) To remove the ice maker, push down on top clip while pulling unit forward. It will slide a short distance before dropping. Carefully continue pulling the ice maker, sliding it along the freezing coil.
Install the new ice maker by performing the steps in reverse.
Time: 5-10 minutes (longer, if there is considerable build up of ice).