Checked hoses & clamps going to and from the pump. All were secure & dry. Bought replacement pump assuming the leak must be at the seal around the pump fitting goes onto the washer motor shaft). Fairly easy to install - took about 20+ minutes without removing the washer outer shell (I didn't want to mess with it, so I just propped up the front of washer with wood blocks to access pump area). But tight quarters made it somewhat challenging- I would have had full/clear access to the pump area if the outer box was removed). Unplug the cord, and remove the two hose clamps, & hoses from pump. Removed the two metal clips holding the pump to the motor shaft. Slid off the old pump (use a small container to catch a small amount of water). Do reverse to install the new pump. The leak was gone.