Joseph W Minooka , IL July 17, 2016 Oe code Verified pump was clear and clean, found no debris. Made jumper harness from old extension cord, pump worked properly. Verified all connections to pump, no problem found. Suspected main board, verified after 49 minutes with AC volt meter installed into pump connector, when pump failed, volt meter read OL. Restarted cycle and occurred again. Removed control panel with Phillips screwdriver, swapped main board. I suggest setting display panel on soft surface as I scratched my display when I turned it over to replace main board. Re assembled, plugged into wall outlet, ran 2 separate rinse and spin cycles, fixed! 12 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes