1. Unplug range from power source.
2. Remove screws necessary to remove rear panel over the range controls.
3. Carefully unplug the white display cable connector from display housing. You will have to squeeze the bottom connector clip to unplug.
4. Remove the two mounting screws from the control panel circuit board.
5. Carefully push side clips away from the circuit board and free it from the housing.
6. Now the display will be exposed. Carefully remove the display from its housing by depressing the black clips.
7. Install new display into the housing clips being sure the connector is on top.
8. Reinstall the control panel circuit board into the housing clips and secure with the two screws.
9. Re-connect the display connector.
10. Re-install the rear panel and secure with screws.
11. Plug range into power source and test display functions.