Micah P Cocoa , FL June 17, 2016 Soap dispenser not dispensing soap Removed the six lower torx screws and removed the lower, metal door cover. I kept the four upper torx screws and control panel in place. Removed wire connector from soap dispensor selenoid and ran the washer with a multimeter connected to the wire harness. After about 3 cycles or approximately 5 minutes I was able to confirm the control panel increasing the voltage from about 2 or 3 volts to 120. After confirming the solenoid was the problem I removed the 3/16 screws from the old dispenser and cleaned the old deposits from where the dishwasher and dispenser gasket meet. Installed the new dispenser with the same screws. 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes