Took a gamble on separating the glass top from the metal encasing containing the shorted out modules. No videos or explanations for my particular model. The top is held to the bottom by way of 2 #15 torx screws per burner ( 4 total) Once they were out, pried the top from bottom with thinnest putty knife available. Be careful to SLOWLY pry all the way around the unit so you can lift straight up. My burner gaskets were pretty much welded on at this point in its life so order a new set IMHO. Separate the burners from top by gently twisting and pulling up. Next grab the top from middle sides and lift up, it will be sticky but the weight of the bottom metal unit will win. Now you can rest the top back down, separate the burners and lay next to their opening as you need to remove the piezo wires from igniters. Be careful with the porcelain bodies. Now that the burners are removed lift and set top aside. Voila your innards are now exposed to service. It goes without saying that BEFORE you do anything you have shut off gas valve and turned off the breaker. Good luck.