Mike B Reston , VA September 16, 2019 Appliance: Model WHIRLPOOL WFG505M0BS0 Stove had no anti tip bracket Great! The part was exactly what was needed. Actually, this part is practically "universal" because each of the 2 "legs" (it's shaped like an "L") are a different length - so one or the other should fit almost any stove "foot". It comes with no instructions but installation is simple. The object is to make sure the cutaway "slot" lines up perfectly with one of the stove's rear "feet". When the stove is pushed back into position against the wall, the stove's rear foot will slide right into that slot and hold the stove down so it can't tilt forward. 1) Slide the bracket over the stove's rear foot (either one) 2) Measure from the edge of the bracket to the nearest side of the stove. 3) Mark that measurement on the back wall, measured from the side of the adjoining cabinet 4) Don't forget to add 1/4" or so, if the countertop overhangs the side of the cabinet. 5) Place Bracket against the mark on the wall, and screw horizontally (lower holes) into the floor plate (the 2x4 lying on the floor behind the drywall). 6) Slide stove back into position. Rearfoot should slip into the Bracket's slot. 7) Test, by grabbing the rear "Control Panel" of the stove, and pulling forward. 8) If the stove won't tilt forward - you've succeeded! Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes