My GE microwave PEM31DF1BB was making a grinding noise. I narrowed it down to the turn table by running the Microwave with the turntable off and the noise stopped. Accessing the motor was a challenge. This microwave is a under mount model that does not have a exhaust vent built in like most under mounts available. It is small like a counter top model. It took the place of the old one from 1997. To access the motor there is a metal plate on the bottom that needs to be cut out. I used a Dremel tool. It had to be designed this way, there’s a note stamped in the metal to be cautious of sharp edges after removal. After the door was cut off the motor was held in by one screw. Easy to swap out motor then turn the door 90 degrees attach with one screw and your done. It took more time to cut the hatch out in the bottom than the 5 minutes to swap out the motor. What I had to do is not like most GE turntable motor replacements my unit is different than any one I saw on YouTube.