Removed top by sliding it back (4 screws), removed back cover with 4 screws, removed electric panel with one screw and 3 connectors, removed front by removing the bellow/boot ring and 4 screws. There are a couple more screws in the soap dispenser unit and down at the drain location. Two dampers in the front on either side and one in the back. On the front ones we pushed out the pins (deep socket highly recommended to hold down the locking notch), on the rear one you have to remove the upper support (4 screws) because the pin doesn't have space to slide out. The dampers were so damaged they had leaked hydraulic fluid. Installed the new dampers first (to push the pins back in you might need help from a hammer and/or a crescent wrench), then the rear cover, front cover, electric panel and top cover. The worst part was the reinstallation of the bellow/boot ring; do some youtube, one of them recommended you place the spring in position at the bottom and insert the ring in the groove in a clockwise motion. When you can't go anymore, pull the right part of the spring with locking pliers while you hold the spring in place with your left hand; an extra hand was most useful to push the last part in place. Washer is now working like-new.