First I had to get the washer into an open area so I turned the water off and take hose fittings off of water valve in wall. Also unplug and remove drain hose from dump. To remove instrument panel and housing I used the website applianceassistant.com, there is a good video on how to do so. It is very easy. Make sure to keep track of any hardware removed. After housing was pulled away at the bottom/front of the wash tub you will see a plastic white piece that has two hoses going to it (discharge pump). Use the pliers to loosen the clamps and remove the hoses. There are two metal clamps holding the pump in place, one on top and bottom use a flat head screw driver to pop the clips out of place. You will be able to pull the pump off at this point. On mine at the bottom of the pump housing there was a discolored (Brown) area where the water was leaking. I also ran some water through the bottom opening of the pump to make sure that was the problem. To install the new one just reverse the steps. I found this to be a very easy fix, no electrical testing needed and part was easily accessed.