Do-It-Yourself Story

I replaced the spin basket assembly. There was some wear where the shaft goes through the bearings. I week or so earlier I replaced the two bearings and seal on the rear tub enclosure. They were only part of the problem as the shaft of the spin basket was also worn or had a slight bend. The replacement was complete in about 90 minutes since I was very familiar with what need to be done. What was amazing was that I ordered the part on a Friday afternoon around 4:00 PM EST and the part was delivered Saturday morning. The washer is now as quiet as the day it was new. I know I saved several hundred dollars doing this repair myself. Note: The tub assembly is much easier to remove with two people. There are several Youtube videos to guide along the way. Good luck