If I had a light load and gave the basket a bit of a push it would spin but slowly. Research showed it could be three parts so I ordered them all. Neutral Assembly Pack, Washer motor drive coupling, clutch assembly. Total of about seven hours taking my time plus two trips to the auto parts store for silicone and snap ring pliers. Trips to parts store consumed an hour, roughly. Quite sure this repair saved me a few hundred dollars. Time well spent. Would have been easier with a work bench. Had to rig a fixture to hold the transmission to take it apart. Everything went in fairly easy. Left old oil in transmission. Didn't want to deal with the mess. Videos helped a LOT. There was one on YouTube for the Neutral Assembly pack. Didn't really need the motor coupling but while I was in that deep I put it in anyway. Washer spins just great now. Noticed the teeth on the inside of the agitator where the agitator dogs engage are all but gone. So I ordered a new agitator assembly. I can drop it in when it gets here. Probably a ten minute job at worst.