The part is so new no video so I went onto a similar part and watched video that got me about 80%. Then, called and customer service sent me a service Manual but this still was not specific so I broke the old to get it out and in the process figured out how to do it correctly. So I installed the last bit of it which was the bezel through the machine top by myself correctly. So you take the old one out by pushing out to the right from the bottom side using a screw driver for leverage. It will then lift up and then slide out to the left above the machine and come off. To put in, slide in to right from bottom and then engage left side by sliding to left and clicks in place. Then put wires under clips on hood side. Go through with wire and connect.