After looking online for similar problems, most answers suggested replacing the Control Board. Very easy to replace, a total of 5 or 6 bolts to remove it after unplugging everything. To make unplugging things easier it helps to depress the locking tab and then pull, not both at the same time. Otherwise, the connectors only go in one slot. Just pay attention to your orange sensor tube and make sure it goes back on the board.
Access to the panel is also very easy and uses the same size bolt, you will need a longish screwdriver and nut driver. Just look on the back top of the washer, remove two bolts, one on each side, slide it to the side and remove the metal backing. The top then slides to the slide and pulls forward. Don’t pull hard to avoid damaging any connectors.