I had initially removed the entire dispenser from the freezer door (which was a very simple operation). Shortly after starting the facade replacement, I realized that the dispenser could have just stayed in the door. Carefully and slowly peel the old facade sticker away. If it splits during the removal, as mine did, the old adhesive will need to be removed. Something like Goo-Gone would be best. I ended up alternating WD-40 and rubbing alcohol. Do NOT use acetone based products. The dispenser is made of a plastic that will soften if exposed to acetone. After the old sticker and glue is gone, carefully align the new facade and set into place being careful not to trap any air bubbles. Note: this product uses excellent glue, and once installation is started, any attempt at repositioning will most likely ruin the sticker.