Parts for Dacor ER30GSCHNGH: Door Assembly Parts

A replacement dryer door handle assembly that restores secure door opening and closing for affected dryer models. Replaces broken, cracked or loose handles so the door can latch and operate normally. What it does

• Replaces a damaged or worn dryer door handle so the door can open and close reliably.
• Helps stop handle wobble, cracking, or pieces breaking off during use.
• Addresses symptoms like a loose handle, handle that won't engage, or difficulty opening the dryer door.
• Works with the existing door latch and mounting points to restore normal operation.

• Disconnect power to the appliance before starting repairs to avoid electrical or injury hazards.
• Basic hand tools (screwdriver) are typically required; follow the appliance's service manual for access steps.
• Keep fasteners and mounting hardware organized.

This Torx-head service screw replaces a missing or damaged #10-32 x 2 inch screw used to secure appliance panels and components, restoring proper fit and reducing noise from loose parts. What it does:

• Secures panels, brackets or service access covers to restore proper alignment
• Prevents rattling, vibration noise and movement caused by loose fasteners
• Replaces stripped, bent or missing service screws for safe operation
• Matches OEM thread size and length for a correct fit when listed for your model

• Use the correct Torx driver and proper-sized socket or bit to avoid cam-out
• Tighten until snug; do not overtighten to prevent stripping threads or damaging panels
• Disconnect power and follow manufacturer safety guidance before accessing internal components

This door liner weldment replaces a damaged or warped inner door liner to restore a proper seal and appearance. It's a direct-fit service part used when the door interior is cracked, dented, or separating from the outer door. What it does:

• Replaces the inner plastic liner that supports door components and helps keep the door airtight
• Restores proper alignment and seating of the door, reducing leaks, drafts, and cooling loss
• Eliminates cracks, chips, or separation that can trap dirt or moisture and impair performance
• Provides the structural backing for mounting trim, gaskets, and hardware

• Disconnect power to the appliance before beginning any repair
• Removal typically requires removing door trim, screws, and any retained clips—use appropriate drivers and keep track of fasteners
• Handle the liner carefully to avoid sharp edges and protect the door outer panel during replacement

This service window gasket seals the appliance door glass, keeping heat, moisture and lint inside for reliable performance and safer operation. It replaces a worn or damaged door seal to restore a proper fit and reduce air leaks. What it does:

• Seals the window-to-door interface so hot air and lint stay inside the cabinet
• Prevents steam and moisture escape that can affect drying performance
• Helps reduce noise and rattling caused by a loose or torn seal
• Visible damage, gaps, or persistent air leaks are common signs this part is needed

• Disconnect power (and gas if applicable) before starting any repair
• Replacement typically requires removing the door and carefully handling the glass
• Inspect mounting channel and fasteners; replace any damaged clips or screws