Parts for Ge J2B912WEK2WW: 04 - Door & Drawer Parts

Replacement oven rack for electric and gas ranges. Installs inside oven cavity. Needed when original rack is missing, damaged, or warped from use.

Broiler pan for ranges and ovens. Installs in main oven cavity to hold food under broiler element. Replace if cracked, warped, or heavily stained.

Broiler pan for ranges and ovens. Installs in main oven cavity to hold food under broiler element. Replace if cracked, warped, or heavily stained.

Includes 12 washers.

This vent trim is the exterior finishing piece that surrounds and protects your dryer vent opening, restoring a clean, factory appearance and helping direct airflow. Designed to replace a worn, damaged or missing vent trim. What it does:

• Covers the dryer vent opening and provides a finished exterior trim
• Helps direct exhaust airflow away from the cabinet and wall
• Restores proper fit and appearance after damage, rust or corrosion
• Reduces gaps that can allow pests, debris or drafts into the vent area

• One metal vent trim

• Basic removal and replacement; verify power is off to adjacent appliance before working nearby
• May require removing screws or clips and aligning trim into vent opening; reinstall fasteners securely
• Check surrounding seals and vent duct for damage while replacing trim

Replace your oven door gasket when frayed, hardened, or heat leaks around the door. Forms an airtight seal to maintain cooking temperatures. Verify fit by model.

This speed nut is a clip-on fastener that provides threads for a screw on the appliance. It secures sheet-metal panels, brackets, or trim and helps keep assemblies tight under vibration and repeated use.

• Provides captive threads so a screw can tighten into thin sheet metal
• Helps secure panels, brackets, and trim pieces in place
• Replace if a screw spins without tightening, a panel rattles/feels loose, or the original clip is missing or damaged
• Restores a snug, reliable attachment point without a loose nut

• Disconnect power and, if applicable, shut off gas; allow the appliance to cool before servicing
• Note the clip's orientation; slide it onto the panel edge or stud as designed
• Start the screw by hand to avoid cross-threading; do not overtighten
• Wear cut-resistant gloves when handling sheet-metal parts

Includes 12 screws.

Side

Insulation strip that installs along the bottom of your electric range door. Replace if torn, compressed, missing, or damaged to restore proper fit.

Oven door glass window pack for viewing food while cooking. Replaces cracked, shattered, or broken glass. Installs inside the oven door frame assembly.

Inner welded panel assembly for range control/backguard structure. Restores secure fit and alignment. Replace if bent, cracked, or damaged to stop rattling.

Secures the lower storage drawer assembly to your range cabinet. Replace this stamped metal bracket if cracked, bent, or missing to restore alignment.

Handle mounting

Hex

Replace cracked, rusted, or chipped trim at the bottom of your range oven door. Installs with screws (sold separately) after removing the door.

Includes 12 screws.

Secures the range door to the cabinet frame for proper alignment. Replace if your bracket is cracked, bent, or missing to restore door stability and fit.

Positions and supports oven door glass to maintain proper alignment. Replace if worn, cracked, or missing to prevent glass rattling and gaps.