Parts for Ge JCTP30SP1SS: 04 - Door Lock Parts

This oven door latch is the replacement latch assembly that secures the oven door closed so the appliance can maintain temperature and operate safely. It restores a positive door catch for proper cooking performance and safety. What it does:

• Locks and holds the oven door closed during operation to help maintain oven temperature
• Provides the mechanical catch for the door to engage and stay shut
• Common symptom: door won't stay closed or latch properly
• Common symptom: oven won't complete certain cycles or reach temperature because the door won't latch

• One oven door latch assembly

• Disconnect power to the appliance before beginning work to avoid electrical shock
• Access may require removing the oven door or inner door panel; follow the oven manufacturer's service instructions
• Handle glass and sharp edges carefully and keep screws/fasteners organized

This silicon controlled rectifier (SCR) is an electronic switching component that controls current flow in appliance control circuits, helping regulate power to heaters, motors, or other loads for stable operation. What it does:

• Switches and regulates current in control boards and power circuits
• Can prevent power from reaching a heater, motor, or element when failed
• Helps protect downstream components by controlling surge/current flow

• Disconnect power to the appliance before servicing to avoid shock.
• Handle the SCR carefully to avoid electrostatic discharge (ESD) damage.
• May require board-level replacement or soldering skills.

This factory screw secures components within your appliance, keeping panels, brackets, and other parts tight and aligned. Replacing a missing or stripped screw helps eliminate rattles and restores a solid, properly mounted assembly.

• Fastens appliance components to frames, brackets, or cooktop/oven structures
• Replaces missing, rusted, or stripped hardware
• Helps address loose or rattling panels and misaligned trim
• Restores a secure fit after service or cleaning

• Disconnect power; if gas, shut off the gas supply. Allow the appliance to cool completely
• Match the screw to its original location and length for proper fit
• Use the correct driver; start threads by hand to avoid cross-threading
• Tighten snugly without overtightening to prevent stripping metal or plastic