Parts for Bosch HBE5451UC/01: Door Parts

Replace a bent, warped, or missing wire oven rack. This grid slides into side rails to hold cookware at proper cooking positions inside your wall oven.

Replacement baking tray for wall ovens. Holds food while baking or roasting. Replace if your original tray is warped, rusted, or missing.

Replace a failed top heating element if your wall oven won't heat properly or cooks unevenly. Restores normal baking temperatures. DIY-friendly repair.

Oven not cooling properly after self-clean or fan not running? This convection fan motor restores air circulation. Moderate DIY repair, 30-45 minutes.

This deflector redirects airflow and protects nearby components inside the appliance, helping maintain proper circulation and preventing direct contact with moving parts. It's a simple replacement that restores intended air direction and component shielding. What it does:

• Guides internal airflow to improve circulation where the original guide is damaged or missing
• Shields adjacent parts from direct heat or contact that can cause wear or chafing
• Stops rattling or vibration caused by a broken or loose deflector
• Helps maintain consistent performance tied to proper airflow routing

• One deflector

• Disconnect power (and gas if applicable) before servicing
• Access may require removing exterior panels or access panels — follow factory service instructions
• Inspect surrounding fasteners and mounting points; reuse or replace as needed to secure the deflector

Replace your wall oven door seal to prevent heat loss and improve cooking efficiency. Essential when worn or damaged. Verify fit with your model number.

Oven temperature off or cooking unevenly? This sensor monitors temperature and signals the control board. Fixes inaccurate readings and restores proper cooking cycles.

Wall oven won't heat or turn on? This power control module distributes electricity to heating elements and components. Moderate DIY repair.

Replace a faulty bottom heating element when your wall oven won't heat properly or bakes unevenly. Restores proper baking temperature and performance.

Replace your wall oven's interior light bulb to restore visibility while cooking. Install when bulb burns out or flickers. Verify fit with your model number.

This lever is a small mechanical actuator used in select Bosch appliances to engage or release a linked mechanism, restoring smooth mechanical operation and control feedback. It provides a direct, OEM-style fit when the original lever is worn or broken. What it does:

• Transfers motion from a knob, button, or latch to the connected mechanism so controls operate correctly
• Helps restore proper engagement or release when the original lever is cracked, bent, or missing
• Commonly linked to control panels, latches, or dispenser mechanisms and affects tactile feel and function
• Safe, mechanical replacement—no electrical function or wiring changes required

• One lever

• Turn off and unplug the appliance or switch off power at the breaker before beginning work
• Remove only the panels and fasteners required to access the lever; keep track of screws and small parts
• If the lever connects to a spring, clip, or linkage, note orientation before removal for correct reassembly

Replacement cap for wall oven. Covers and protects internal components or control panel openings. Order if original cap is cracked, broken, or missing.

Wall oven bushing provides smooth movement for oven components. Replace if worn, cracked, or causing noise. Verify fit with your model number before ordering.