Parts for Bosch HBN5620UC/01: Door Parts

Fix a damaged or worn oven door interior with this inner door panel. Restores structural support, provides mounting for hardware, and protects components.

Replace your wall oven door seal gasket to restore airtight closure and prevent heat loss. Maintains proper sealing for efficient cooking. Confirm fit by model.

This is the inner glass panel that sits inside the oven door assembly. It helps insulate the oven cavity and keeps heat from escaping through the door. Replace this panel if it is cracked, shattered, or has visible damage, which can cause heat loss and uneven cooking temperatures.

This is a metal trim plate that frames the oven door, providing a finished appearance and structural support around the door's outer edge. It helps secure the door glass and inner panel in place. Replace this part if the trim is cracked, bent, warped, or if the door panels are separating or not sitting flush.

Replacement spacer for electric wall ovens. Maintains proper clearance and alignment between oven components. Order if original is cracked or missing.

Replacement glass panel for wall oven control and display area. Restores protection and clean appearance when original is cracked, broken, or scratched.

This metal mounting bracket secures internal components and panels to restore proper alignment and reduce rattling. It's a straightforward replacement part that helps keep appliance panels and assemblies firmly in place for reliable operation. What it does:

• Provides a secure attachment point for panels or internal assemblies to prevent movement and vibration
• Helps correct alignment issues that can cause rubbing, gaps, or noise
• Restores the original fit where a bent, cracked, or missing bracket caused loose parts
• Works with the appliance's existing fasteners and mounting points

• Remove power and, if applicable, disconnect the appliance from water before beginning work
• Use the factory fasteners or OEM replacement screws to secure the bracket in the original location
• Verify alignment of the attached panel or assembly before fully tightening fasteners

Replace your wall oven's broken or snapped door bracket. This mounting bracket secures the lower oven door panel and attaches door clips for proper alignment.

Replacement washer for electric wall ovens. Installs between components to provide secure spacing and prevent wear. Order if original is missing, damaged, or worn.

Replacement mounting bolt for wall ovens and warming drawers. Secures oven to cabinet or frame. Order if original bolt is missing, stripped, or damaged.

This cap is a small protective cover used to shield electrical terminals or connectors, helping prevent accidental contact and reducing exposure to dust and debris. It keeps connections tidy and helps maintain reliable operation. What it does:

• Covers and protects exposed electrical terminals or connector ends
• Helps prevent accidental shorts from contact with metal objects
• Reduces dust and debris accumulation around the connection
• Keeps wiring routed and secured for a neater installation

• Disconnect power to the appliance before inspecting or replacing electrical parts
• Remove old/damaged cap and snap new cap into place over the terminal or connector until fully seated
• Use basic hand tools if necessary; avoid forcing the cap to prevent damage
• If terminals are corroded or damaged, replace those components instead of relying on the cap alone