Parts for Electrolux CEW30GF6GWC: 11 - Door Parts

Replace your range's control panel assembly if the original is cracked, damaged, or worn. This panel installs on the front and houses controls and displays.

Replace worn, damaged, or missing sound dampening insulation in your gas range. Installs inside the range cabinet to reduce noise and vibration.

Replaces cracked, broken, or fogged inner oven door glass panel. Restores visibility into the oven cavity and helps maintain proper heat retention.

Mounting screw for range installation and assembly. Replaces lost, stripped, or damaged screws that secure panels, brackets, or internal components.

This replacement door gasket seals the refrigerator door to help maintain proper cooling and reduce air leaks. It restores a tight seal to help prevent temperature fluctuations and excess energy use. What it does:

• Forms an airtight seal around the refrigerator door to keep cold air inside
• Helps reduce frost buildup and warm spots caused by a failing seal
• Can improve cooling consistency and reduce compressor run-time when worn gaskets are replaced
• Fits into the door channel and compresses to close gaps between the door and cabinet

• Disconnect power to the appliance before starting any work
• Clean the door channel thoroughly and remove old gasket before installing the new one
• Warm the gasket to improve flexibility for easier installation; avoid open flames or high-heat tools
• Press gasket fully into the channel and check for even compression around the entire door; trim only if the manufacturer explicitly states trimming is required

Spacer component for gas ranges. Installs between parts to maintain proper alignment and spacing. Replace if cracked, broken, or missing during repair.

Factory replacement support plate for electric and gas ranges. Covers and supports internal components. Replace when bent, cracked, or missing to restore proper alignment.

Chrome screw secures handles, door trim, and internal components in ranges and ovens. Replace if lost during cleaning, stripped, or missing after moves.

Size: 3/4 inch od x 1/4 inch id.

This is a replacement rating/nameplate label that restores the appliance identification and safety information printed on the cabinet. It helps keep model, serial and electrical ratings readable for service and safe operation. What it does:

• Replaces a torn, faded or missing rating/nameplate so model and serial info is visible for service.
• Restores printed electrical ratings and manufacturer markings used during diagnostics.
• Helps meet safety and inspection needs by returning legible identification to the appliance.
• Simple peel-and-stick replacement—no tools required for the label itself.

• One replacement adhesive rating/nameplate label.

• Clean and dry the surface thoroughly before applying; remove old adhesive residue.
• Align the label carefully, peel backing, and press firmly from one edge to the other to avoid bubbles.
• Do not place over vents, controls or moving parts; ensure label location is the original flat area on the cabinet.
• This is a non-electrical cosmetic/identification part—no wiring or power disconnection is required to apply, but follow general safety precautions when working on appliances.

Chrome screw secures handles, door trim, and internal components in ranges and ovens. Replace if lost during cleaning, stripped, or missing after moves.