Parts for Frigidaire FEB702BBBF: 04 - Door Parts

A molded insulation shield that protects and directs cold-air flow inside the appliance cabinet to help maintain proper cooling and reduce moisture buildup. Fits behind interior panels where insulation support is needed. What it does

• Replaces a damaged or missing insulation shield that can allow air leaks or improper airflow
• Helps keep cold air directed to the evaporator area for more consistent temperatures
• Can reduce localized frost or moisture accumulation caused by poor airflow or damaged barriers
• Used when interior panels or insulation supports are cracked, warped, or detached

• Disconnect power to the appliance before beginning any repair
• Remove outer and inner cabinet panels as needed to access the shield; keep fasteners for reinstallation
• Handle edges and mounting points carefully — wear gloves to avoid cuts and to protect insulation

This is a direct-fit refrigerator door handle that restores a secure, easy-to-grip surface for opening and closing the appliance. Replaces a cracked, loose or missing handle to improve usability and appearance. What it does

• Provides a sturdy grip for opening and closing the refrigerator door.
• Replaces handles that are cracked, broken, loose or missing.
• Restores proper leverage so doors open without using the door edge.
• Helps maintain the door's original fit and finish when properly installed.

• Basic hand tools (screwdriver or nut driver) typically required; refer to your model's service sheet for exact fasteners.
• Handle secures to the door with the original mounting hardware or clips—retain and reuse existing screws when possible.
• Align handle on the door before tightening; tighten fasteners snugly by hand to avoid stripping or cracking the handle.

This replacement screw secures appliance panels, brackets, and internal components. It restores a tight, rattle-free fit and proper alignment when an original fastener is missing, stripped, or corroded.

• Fastens metal or plastic parts to the cabinet/frame
• Helps maintain alignment and reduce vibration or rattling
• Direct replacement for lost, damaged, or rusted hardware
• Keeps covers and brackets safely in place

• Disconnect power before servicing; for gas appliances, also shut off gas supply
• Match one-for-one with the original screw; verify length/type before installation
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening
• Use the correct driver bit to prevent stripping the screw head

This replacement screw secures appliance components so brackets, shelves, trim, or panels stay firmly in place. Install a new screw when the original is missing, stripped, or corroded to restore a tight, rattle-free fit.

• Fastens brackets, panels, trim, or covers to the cabinet or liner
• Helps maintain alignment and reduce vibration and noise
• Direct replacement for a missing, rusted, or stripped fastener
• Use wherever your model's parts diagram specifies this screw

• Disconnect power before servicing; shut off water if working near water lines
• Match thread and length to the original location as shown in your model's parts diagram
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening (especially into plastic)
• Retain and transfer any original spacers or clips used with this fastener